Mold Removal and Testing

Pure Maintenance has developed a two step dry fog technology that allows us to keep your home intact, dry, and safe during treatment

Step 1: InstaPURE

InstaPURE is a fog and disinfectant that finds and destroys mold spores throughout your home. It turns the mold spores into inert matter, allowing you to breathe easy knowing that the mold is gone and your family is safe. InstaPURE disinfects any surface that is touches. It is also used in daycares, hospitals, cars, and gyms.

Step 2: EverPURE

EverPURE is an antimicrobial fog that clings to the surfaces in your home to aid in mold prevention after the InstaPURE application. EverPURE is EPA verified with 90 days of protection once it is applied. It doesn’t leave a residue on the surfaces it is applied to, but when any bacteria or viruses land on a surface with EverPURE, they are destroyed on contact.

InstaPURE and EverPURE are both EPA-approved in all 50 states.

 

Why Demolition-Free Mold Removal?

Effective

The Pure Maintenance dry fog technology can fill up an entire building with an EPA-approved sterilant that kills bacteria, mold, and viruses - cleaning surfaces and destroying airborne spores. This process also cleans out furniture, air ducts, fabrics, and behind the walls. We guarantee our results because it is so effective and will make your home a safer place.

Affordable

Because we are demolition-free, we can do the job quicker and more effectively without the cost of tearing up carpets and digging into walls. We transfer these savings to you. We provide free estimates and inspections, and our prices are usually much less than any competitor.

Quick

Other mold removal processes can take weeks to clean just one room in your home or building, and then you have to replace anything that was damaged in the process. With our dry fog technology, the job can be finished in as few as 4 hours.

Non-invasive

Because of the quick process with our dry fog solution, we are in and out of your home or office in just hours. There is no need to quarantine off a section or your home to allow our workers to come and go over the course of weeks. We’ll just pack up a truck, bring a few small equipment items, and 4 hours later you will have a mold and bacteria free home.

Mold Inspections and Testing

If needed, Pure Maintenance provides air quality testing, tape testing, and ERMI testing to determine where the mold is in your home.

  1. Air quality testing is the most common form of testing in the industry, and usually requires a 75 liter air sample from inside the building that is pulled through a small filter.
  2. Tape tests are good for determining the type of mold if you can visually see mold growth in your home.
  3. ERMI testing is the most accurate testing available, but also the most expensive. These tests are taken by pulling mold and dust from a carpet with a vacuum and filter system.

Each test will be run through an independent third party lab, and an analysis and report will be returned to the homeowner to help determine the best course of action.